F5 Corpus
8.3.3
Slowly flashing red LEDs, 1–2 LEDs
The batteries must be charged immediately.
8.3.4
Rapidly flashing, 1–10 LEDs
A fault has been detected in the wheelchair's electronics and the
wheelchair may not be driven.
1. Switch off the wheelchair.
2. Check that all visible cables and the cable to the control panel are
connected correctly.
3. Switch the wheelchair on again. If the fault persists, count the
number of flashing LEDs and check for a possible cause and
remedy in the following table.
4. Do not use the wheelchair until the problem has been remedied
or you have received other information from your service
provider.
284
Troubleshooting