Ma Value; 24 Volt - GE Druck DPI 610 User Manual

Advanced Task

mA Value

Press the OUTPUT key and select mA VALUE from the output menu. The procedure is
shown below:
SELECT SORTIE
PRESSION
PRESSION EXT
PAS mA
RAMPE mA
VALEUR mA
• For current sourcing applications, turn on the 24V supply as shown below. For
current sinking applications, connect an external supply as shown on page 25 and
leave the 24V supply switched OFF.
• Use up and down
made, a status display indicates OK. A status display CHECK LOOP indicates a fault
in the external loop i.e. supply fault or open circuit.

24 Volt

Press the OUTPUT key and select 24 VOLT from the Output menu. The procedure is
shown below:
Note: The 24V selection is located on the second page of output functions.
OUTPUT
SELECTIONNER
SORTIE
Note: To conserve battery power, keep the 24V supply switched off when not in use (even
if the output is unloaded).
K415 Issue No. 1
CHOISIR SORTIE
INT
cursor keys to adjust output current level. While the loop is
SELECT SORTIE
24 VOLT
OFF
PAS DE SORTIE
24V OFF
FCT. : CONFIG.
MODE ENREG. RAPIDE
SORTIE
NOUV VAL
OK
VALIDER
SORTIE
SELECT SORTIE
24 VOLT
PAS DE SORTIE
28
Select Output
REGLER NIVEAU
bar
mA
ON