Soft Keys; Cursor Keys - GE Druck DPI 610 User Manual

INTRODUCTION
SOFT KEYS (Figure 1)
Three soft keys, designated F1, EXIT and F2, are situated immediately below the display
as shown below. These keys have their function allocated by the instrument software
which is indicated in the bottom of the display (Voltage for F1 and Units for F2 in this
example). They are used to select menu (program) options and are fully described under
the appropriate section headings.
CURSOR KEYS (Figure 1)
The cursor keys consist of a block of four keys, designated up , down , left
right . In programs where options need to be selected from a list, (e.g.) the TASK
selection program, the up
options, from which it can be selected by the ENTER key. In TASK mode, where more
than one page of options are provided, the left
between pages.
12
11
1 Test port, connect to unit under test
3 Cover (external interfaces)
5 Electrical outputs
7 Function (soft) keys
9 Vent port
11 Pump
Figure 2 - DPI 610/615 Calibrator Controls
and down
1
Summary of Functions
cursor keys are used to highlight one of the
and right
2
9
10
2 Hard keys
4 Electrical inputs
6

Cursor keys

8 Release valve (releases pressure through 9)
10 Select positive or negative pressure
12 Fine pressure adjuster
5
and
cursor keys will switch
3
7
8
K415 Issue No. 1
4
5
6