Min/Max Process Function; Filter Process Function - GE Druck DPI 610 User Manual

Advanced Task
Max/Min Process Function
To set-up an input display to show max/min and present input reading, enable
MAX/MIN from the process menu and press F1 (SETTINGS) to provide RESET
function. The display now shows the max/min values as follows:
FCT. : CONFIG
MODE ENREG. RAPIDE
ACTUEL
RESET
MAX/MIN

Filter Process Function

To apply the low pass filter to a selected input, enable FILTER from the process
menu and press F1 (SETTINGS) to provide access to the filter parameters. Two
settings are required, Time to Settle and Band.
To examine the current filter settings and exit without change, press the EXIT key.
The set-up procedure is as follows:
CONFIG.FILTRE
PERIODE
2 Seconds
HEURE =
BANDE = AMPLITUDE MAX
QUI DOIT FILTREE VARIATIONS
SUPERIEURESA LA BANDE DU
FILTRE
BANDE = 1.5 % FS
CHANGER
VALEUR
24V OFF
Reset Max/Min display at any time by pressing the
F1 key.
To quit max/min, press INPUT, select MAX/MIN
from process menu and switch the function off.
SELECTIONNER
VALEUR
23
Process Functions
CONFIG.FILTRE
PERIODE
HEURE = 2 Seconds
BANDE = AMPLITUDE MAX
QUI DOIT FILTREE VARIATIONS
SUPERIEURESA LA BANDE DU
FILTRE
1.5 % FS
BANDE =
CHANGER
VALEUR
SELECTIONNER
VALEUR
K415 Issue No. 1