Process Functions - GE Druck DPI 610 User Manual

Advanced Task

Process Functions

If required, the following process functions are available on the input display but only in
ADVANCED task. If the instrument is in any other mode i.e. BASIC or any other task
mode, the input and output displays must first be configured in ADVANCED task.
Note: PROCESS functions are not available to the output channel.
A summary of the process functions follows:
Tare
Max/Min
Filter
Flow
% Span
Following selection of ADVANCED from the task menu, press the INPUT key. Use the up
or down cursor keys to select the required input. Press the PROCESS (F1) key and
use the left or right
INPUT
SELECTIONNER
TRAITEMENT
Press ENTER to switch the process ON with existing settings or F1 to change process
settings (where applicable).
Allows either the current display value or a manually
entered value to be tared off display parameter reading.
Displays running Max/Min and present display values
simultaneously. Resettable via F1 key.
Applies low pass filter function to displayed parameter.
Filter characteristics (Settling time and Band) are user
programmable.
Applies square root function to displayed parameter.
Converts displayed parameter reading to a percentage of
span. Span definable via the F1 key.
cursor keys to enable the process on/off:
SELECT. ENTREE
PRESSION INT
PRESSION EXT
TENSION
COURANT
TEMPERATURE
PROCESS UNITES
ENTR. PROCESS
TARE
MAX/MIN
FILTRE
DEBIT
% ECH
PARAMETRAGES
21
Process Functions
VALIDER
TRAITEMENT
ON
OFF
OFF
OFF
OFF
K415 Issue No. 1