Quick Installation Steps For Administrators; Insert Sim Card; Install And Configure The Handset - ASCOM Myco User Manual

User Manual
Ascom Myco Wi-Fi and Cellular Smartphone
2.

Quick Installation Steps for Administrators

An administrator should perform the following steps to get the handset started:
NOTE: Remove the protective plastic sheet that is attached to the display at delivery before
using the touchscreen to ensure proper function.
1 Insert the micro-SIM card (Cellular handset versions only). Refer to
on page 4.
NOTE: Only micro-SIM size cards can be used in the handset.
2 Close the battery cover, and lock it. Refer to
TIP: The battery has an approximately 50% charge at delivery, and doesn't need to be
charged before use.
3 If desired, change the language. Refer to
4 Enter the handset ID (Easy deployment). Refer to
Handset
NOTE: If not already done as prerequisite, perform Easy deployment. Refer to the
Configuration
5 If desired, configure parameter settings for the site or user. Refer to the
Configuration Manual
2.1

Insert SIM Card

NOTE: Cellular handset version only. Only micro-SIM size cards can be used in the handset.
1 If needed, unlock the battery cover, and remove it.
2 The SIM card slot is located under the clip. Press on the clip to open it fully, and insert
the micro-SIM in the SIM card slot, in the direction as shown on the label.
TIP: If needed, use a tweezer to hold it, then push it into the slot.
3 Close the battery cover, and lock it. The handset starts within seconds if the battery is
charged.
TIP: If the handset does not start, charge the battery, and then long press the Power
button to switch the handset On.
Remove SIM card
1 Open the battery cover lock. Press on the clip to open it fully, and remove the Battery
Pack.
2 Remove the micro-SIM card by using a 3-4 mm screwdriver, or similar tool, in the hole
above the SIM card slot, and pull outwards, until the micro-SIM card can be removed
(with fingers, or a tweezer).
CAUTION: Be careful not to damage the inside of the SIM card slot.
2.2

Install and Configure the Handset

The recommended method to install and configure a handset is through Easy Deployment,
using a pre-configured staging WLAN. If Easy Deployment isn't configured in the system, QR
code setup or manual installation methods can be used. Follow the instructions in the
applicable section below:
26 April 2016 / Ver. D
2. Quick Installation Steps for Administrators
on page 4.
Manual.
for more information.
4.11 Change Battery
15.3 Languages Settings
2.2 Install and Configure the
TD 93066EN
2.1 Insert SIM Card
on page 20.
on page 66.
handset
handset
4