Quick Installation Steps For Administrators; Insert Sim Card; Install And Configure The Handset - ASCOM Myco User Manual

User Manual
Ascom Myco Wi-Fi and Cellular Smartphone
2.

Quick Installation Steps for Administrators

An administrator should perform the following steps to get the handset started:
NOTE: Remove the protective plastic sheet attached to the display, for proper function of the
touchscreen.
1 Insert the micro-SIM card (Cellular handset versions only). Refer to
on page 6.
NOTE: Only a micro-SIM size card can be used in the handset.
2 Close the battery cover, and lock it. Refer to
TIP: The battery has an approximately 50% charge at delivery, and doesn't need to be
charged before use.
3 Change the language (if other than the default english). Refer to
Settings
4 Enter the handset ID (Easy deployment). Refer to
Handset
NOTE: If not already done as prerequisite, perform Easy deployment. Refer to the
Configuration Manual, Ascom Myco Wi-Fi and Cellular Smartphone.
5 Configure parameter settings for the site, or for the handset user. Refer to the
Configuration Manual, Ascom Myco Wi-Fi and Cellular Smartphone for further
information.
2.1

Insert SIM Card

NOTE: Cellular handset version only. Only micro-SIM size cards can be used in the handset.
1 Unlock the battery cover lock, and then remove the battery from the handset.
2 The SIM card slot is located under the clip. Press the upper part of the clip to open it
fully, and insert the micro-SIM in the SIM card slot, in the direction as shown on the
label.
TIP: If needed, use a tweezer to hold the SIM card, and then push it into the slot.
3 Close the battery cover, and then lock it. The handset starts within seconds, if the
battery is charged.
TIP: If the handset does not start, charge the battery, and then long press the Power
button to turn the handset On.
Remove SIM Card
1 Open the battery cover lock. Press the clip to open it fully, and remove the Battery
Pack.
2 Remove the micro-SIM card by using a 3-4 mm screwdriver, or similar tool, in the hole
above the SIM card slot, and pull outwards, until the micro-SIM card can be removed
(with your fingers, or with a tweezer).
CAUTION: Be careful not to damage the inside of the SIM card slot.
2.2

Install and Configure the Handset

The recommended method to install and configure a handset is through Easy Deployment,
by using a pre-configured staging WLAN. If Easy Deployment isn't configured in the system,
use QR code setup, or install the handset manually through the admin settings menu.
3 October 2017 / Ver. H
2. Quick Installation Steps for Administrators
on page 78.
on page 6.
2.1 Insert SIM Card
4.11 Change the Battery
16.3 Languages
2.2 Install and Configure the
TD 93066EN
on page 24.
6