ASCOM Myco User Manual page 12

User Manual
Ascom Myco Wi-Fi and Cellular Smartphone
Setup using Easy Deployment
A handset is automatically installed and configured, if the VoWiFi system is configured for
Easy Deployment. Refer to the
configure Easy Deployment in the VoWiFi system.
If the handset is successfully installed after the Easy Deployment process, but hasn't
received a messaging number automatically, do the following:
1 If the handset is switched On, switch it Off and then On again.
2 When the handset displays: "No messaging number configured for this device", tap
"Setup number".
3 When the handset displays: "enter messaging number", that is, the phone number of
the handset, enter the number.
4 Press "Done".
CAUTION: If a wrong number is entered, a factory reset must be done, and all handset
configuration parameter settings are restored to the default values. Refer to the
handset Configuration
If the unite system is configured for User log in, enter user log in and password supplied by
the system administrator.
Setup using QR codes
Quick installation and setup can be done by scanning a QR code, if Easy Deployment is
unavailable. The Setup QR code can be created by a system administrator and contains the
parameters necessary to install the handset in the system. Refer to the
Configuration Manual
To scan a Setup QR code, do the following:
1 Locate the
26 April 2016 / Ver. D
2. Quick Installation Steps for Administrators
handset Configuration Manual
Manual.
for instructions on how to create Setup QR codes.
"Setup" app, and tap to open it.
TD 93066EN
for information on how to
handset
5