Replacement-Tightening
Wheel
15 min
Replacement-Tightening
Wheel
1 - You will need
• Standard tool kit
• Protective goggles
• Gloves
• Jack
• Hoist
• Torque spanner
2 - Preliminary procedure
1.
Place the machine in maintenance configuration.
configuration
3 - Criteria of replacement
Replace the wheels and the tyres if any of the following conditions exist :
• Presence of cracks, damage, deformations or other faults on the hub
• Damage on the tire :
Cut or hole >at 3 cm (2 in) in the rubber side wall on the whole tire thickness.
Blister or pronounce lump on the external and lateral membrane.
Damaged wheel stud.
Damage or wear on the side wall to the extent that the reinforcing wire become visible.
• Nonlinear wear of the ground contact surface greater than 10 %.
2420333140
E06.13
• Place barriers around the perimeter of the
work area
3.3.1-Placing the machine in maintenance
E006
107
EN