Installing The Chassis Into A Telco Rack - Supero SUPERSERVER 6017R-TDLF User Manual

S S
UPER ERVER 6017R-TDLF User's Manual

Installing the Chassis into a Telco rack

To install the chassis into a Telco type rack, use two L-shaped brackets on either
side of the chassis (four total). First, determine how far follow the server will extend
out the front of the rack. Larger chassis should be positioned to balance the weight
between front and back. If a bezel is included on your server, remove it. Then at-
tach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack.
Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Figure 2-5. Installing the Server into a Telco Rack
2-8