Installing The Chassis Into A Telco Rack - Supero SC119TQ-R700UB User Manual

SC119 Chassis Manual

Installing the Chassis into a Telco rack

Installing the Chassis into a Telco Rack
1. Locate the two L-shaped brackets (four total).
2. Determine how far the server will extend out the front of the rack. Larger
chassis should be positioned to balance the weight between front and back. If
a bezel is included on your server, remove it.
3. Attach the two front brackets to each side of the chassis, then position the
two rear brackets with just enough space to accommodate the width of the
Telco rack.
4. Slide the chassis into the rack and tighten the brackets to the rack.
Figure 6-6: Installing the Server into a Telco Rack
Note: figures are for illustrative purposes only. Servers should always be installed
in racks from the bottom up.
6-8