Drive Bay Installation/Removal; Removing The Front Bezel; Accessing The Drive Bays - Supero SUPERSERVER 6017R-TDLF User Manual

6-4

Drive Bay Installation/Removal

Removing the Front Bezel

If your system has the optional front bezel attached to the chassis, you must fi rst
remove it to gain access to the drive bays.
1. First unlock the front of the chassis then press the release knob (see Figure
6-4).
2. Carefully remove the bezel with both hands. A fi lter located within the bezel
can be removed for replacement/cleaning. It is recommended that you keep
a maintenance log of fi lter cleaning/replacement, since its condition will affect
the airfl ow throughout the whole system.

Accessing the Drive Bays

Serial ATA Drives: Because of their hotswap capability, you do not need to access
the inside of the chassis or power down the system to install or replace Serial ATA
drives. Proceed to the next step for instructions.
CD-ROM Drives: For installing/removing a CD-ROM drive, you will need to gain
access to the inside of the 6017R-TDLF by removing the top cover of the chas-
sis. Proceed to the "CD-ROM Drive Installation" section later in this chapter for
instructions.
Note: Only a "slim" CD-ROM drive will fi t into the 6017R-TDLF.
Figure 6-4. Removing the Front Bezel
6-5
Chapter 6: Advanced Chassis Setup
1. Unlock
2. Press release knob
3. Remove bezel assembly