Control Panel - Supero SUPERSERVER 6017R-TDLF User Manual

S S
UPER ERVER 6017R-TDLF Manual
Slim CD-ROM Drive (optional)
Power Supply Module
COM Port
Note: the 6017R-TDLF has a single power supply only (Part# PWS-351-1H)
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
Figure 6-1. Chassis: Front and Rear Views
SATA Drive Bays
Dedicated IPMI LAN
USB Ports
System LEDs
System Reset
VGA Port
LAN Ports
6-2
Control Panel
Main Power
PCI Expansion Slot
.