Table of Contents
Advertisement
Installing the Chassis into a Telco rack
To install the chassis into a Telco or post-style rack, use two L-shaped brackets on
either side of the chassis (four total).
1. First, determine how far follow the server will extend out the front of the rack.
Larger chassis should be positioned to balance the weight between front and
back.
2. If a bezel is included on your server, remove it.
3. Attach the two front brackets to each side of the chassis, then the two rear
brackets positioned with just enough space to accommodate the width of the
telco rack.
4. Finish by sliding the chassis into the rack and tightening the brackets to the
rack. See the fi gure on the following page.
Chapter 2: Server Installation
2-9
Advertisement
Table of Contents
