Table of Contents
Advertisement
NIC1/NIC2 LED Indicators
The NIC (Network Interface Control-
ler) LED connection for GLAN port 1 is
located on pins 11 and 12 of JF1, and
the LED connection for GLAN Port 2 is
on Pins 9 and 10. Attach the NIC LED
cables here to display network activity.
Refer to the table on the right for pin
defi nitions.
Overheat (OH)/Fan Fail/PWR Fail/
UID LED
Connect an LED cable to pins 7 and
8 of Front Control Panel to use the
Overheat/Fan Fail/Power Fail and
UID LED connections. The Red LED
on pin 7 provides warnings of over-
heat, fan failure or power failure. The
Blue LED on pin 8 works as the front
panel UID LED indicator. The Red
LED takes precedence over the Blue
LED by default. Refer to the table on
the right for pin defi nitions.
Power Fail LED
The Power Fail LED connection is
located on pins 5 and 6 of JF1. Re-
fer to the table on the right for pin
defi nitions.
Reset Button
The Reset Button connection is lo-
cated on pins 3 and 4 of JF1. Attach
it to a hardware reset switch on the
computer case. Refer to the table on
the right for pin defi nitions.
Chapter 5: Advanced Serverboard Setup
Pin Defi nitions (JF1)
Pin#
9
10
11
12
OH/Fan Fail/ PWR Fail/Blue_UID
LED Pin Defi nitions (JF1)
Pin#
Defi nition
7
Red_LED-Cathode/OH/Fan Fail/
Power Fail5.5V.SB
8
Blue_UID LED
OH/Fan Fail/PWR Fail
LED Status (Red LED)
State
Off
On
Flashing
Pin Defi nitions (JF1)
Pin#
5
6
Pin Defi nitions (JF1)
Pin#
3
4
5-13
GLAN1/2 LED
Defi nition
Vcc
NIC 2 LED
Vcc
NIC 1 LED
Defi nition
Normal
Overheat
Fan Fail
PWR Fail LED
Defi nition
3.3V
PWR Supply Fail
Reset Button
Defi nition
Reset
Ground
Advertisement
Table of Contents
