Fingerprint Reader Board - HP Spectre x360 15 Maintenance And Service Manual

Fingerprint reader board

NOTE: The fingerprint reader board spare part kit does not include the fingerprint reader board cable (spare
part number L15584-001).
Description
Fingerprint reader board
IMPORTANT:
and replacement
Before removing the fingerprint reader board, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
▲ Battery (see
Remove the fingerprint reader board:
1. Release the fingerprint reader board cable from the ZIF connector on the system board (1).
2. Release the fingerprint reader module cable from the ZIF connector on the fingerprint reader board (2).
3. Remove the Phillips PM2.0×3.5 screw (3).
4. Remove the fingerprint reader board and cable from the computer (3).
Reverse this procedure to install the fingerprint reader board.
36 Chapter 5 Removal and replacement procedures for authorized service provider parts
Make special note of each screw and screw lock size and location during removal
Bottom cover on page
Battery on page
29), and then remove the following components:
31).
Spare part number
L15583-001