Fingerprint Reader Board - HP ProBook 450 G10 Maintenance And Service Manual

1. Remove display cable from the clips (1) on the side of the fan.
2. Remove the three Phillips 2.0 × 4.0 screws (2) that secure the fan to the computer.
3. Disconnect the fan cable from the system board (3).
4. Remove the fan from the computer (4).
To install the fan assembly, reverse this procedure.

Fingerprint reader board

To remove the fingerprint reader board, use this procedure and illustration.
Table 6-6 Fingerprint reader board description and part number
Description
Fingerprint reader board
Fingerprint reader board cable (included in Cable Kit)
Fingerprint reader board bracket (included in Bracket Kit)
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. (Select products only) Remove the WWAN module (see
Remove the fingerprint reader board:
1. Disconnect the cable from the ZIF connector (1) on the fingerprint reader board.
Preparation for disassembly on page
Bottom cover on page 37).
Battery on page 46).
WWAN module on page
Fingerprint reader board
Spare part number
N00879-001
N03218-001
N01916-001
37).
42).
51