Cisco Unified Communications Manager Administration Phone Addition; Device Support; Safety Information - Cisco 7925G Administration Manual

Device Support

BAT is included in Cisco Unified Communications Manager 5.0 or later, but it is a plug-in for earlier
Note
releases.
For detailed instructions about using BAT, see the following documents:
• For Cisco Unified Communications Manager Release 5.0 and earlier, see Bulk Administration Tool User
• For Cisco Unified Communications Manager Release 6.0 and later, see Cisco Unified Communications
When using BAT to add a Cisco Unified Wireless IP Phone, use the default setting for the phone load.
Note
The phone load name includes symbols (-, _, .) and BAT does not permit symbols in an entry.

Cisco Unified Communications Manager Administration Phone Addition

Add phones individually by using Cisco Unified Communications Manager Administration. To do so, obtain
the MAC address for each phone before you begin. See
Addition Methods, on page 48
Perform one of the following after collecting the MAC addresses:
• Cisco Unified Communications Manager Release 5.0 or later: Choose Device > Phone and click Add
• Cisco Unified Communications Manager Release 4.x: Choose Device > Add a New Device.
For additional instructions and conceptual information about Cisco Unified Communications Manager, see
the Cisco Unified Communications Manager Administration Guide and Cisco Unified Communications
Manager System Guide.
Device Support
Cisco Unified Communications Manager Release 4.3 and later require a device package or service release
update installed to enable device support for the Cisco Unified Wireless IP Phone. Device packages including
support for the Cisco Unified Wireless IP Phone are available at
sw-voice.shtml.

Safety Information

Review the following warnings before installing the Cisco Unified Wireless IP Phone. To see translations of
these warnings, see the Regulatory Compliance and Safety Information for the Cisco Unified Wireless IP
Phone 7920 Series and Peripherals document that accompanied the device.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
50
Guide for Cisco Unified Communications Manager.
Manager Bulk Administration Guide.
for instructions.
New.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup
Cisco Unified Communications Manager Phone
http://www.cisco.com/kobayashi/sw-center/