Omron H8PS Operation Manual page 90

Section 4 HOW TO USE THE ADVANCED FUNCTIONS
Setting the ADV value
Determining the set
ADV value
Returning to the previous screen
■ Clearing the ADV Function Setting
■ Relationship between the Speed Alarm (upper limit) and the ADV
Function
4-10
Press the [+] or [−] key of the ANGLE keys (*) to
set the desired ADV value (2°, in this example).
* When setting the ADV value by holding the [+] or [−]
key down to change the displayed value quickly, the
displayed value changes more quickly if the other
key is pressed.
(Make sure that "2°" is displayed in Sub-
display (left).)
The ADV function setting for the designated
cam is complete when a value other than "---"
or "0" is entered in both fields in Sub-display.
Press the [ADV] key after finishing the ADV
function setting to return to the previous
screen.
To continue ADV function setting for other
cams, repeat the setting procedure explained
above from the cam No. designation step.
Setting "---" for either the speed or ADV value disables the ADV
function setting for that cam, which effectively means that the ADV
function setting is cleared.
Although the ADV function is disabled if "0" is set for the ADV value,
the cam concerned is included in the "number of cams with the ADV
function", which affects the maximum response speed.
Note that the ADV function setting is not cleared even if the target cam
program is cleared using the [CLEAR] key.
(Refer to "3.8 Clearing the Settings".)
With an 8-output model, cam 7 may be allocated to the speed alarm
(upper limit).
Although ADV function setting is still allowed under these circum-
stances, the actual operation of the output is the speed alarm (upper
limit).
TST
STEP
CAM
TST
CAM STEP