Designating The Bank Using The Keys - Omron H8PS Operation Manual

4.8.3

Designating the Bank Using the Keys

Use the [BANK] key on the front of the Cam Positioner unit to designate the bank in the programming and
test mode.
Make sure that the display for the bank switching method is "key". (Refer to "4.8.6 Selecting the Bank
Switching Method (F8)".)
<Example>
Switching the bank from bank 0 to bank 2
TST
CAM STEP
Press the [BANK] key.
TST
CAM STEP
Press the [BANK] key.
TST
CAM STEP
Press the [WRITE] key.
TST
CAM STEP
* Operation may be started from any display screen.
(PRGM mode or TEST mode)
PRGM PRGM
TEST TEST
RUN RUN
The displayed bank number starts flashing.
The bank number increases each time the [BANK] key
is pressed. Press the [BANK] key repeatedly until the
desired bank number is displayed.
(The bank is not switched at this stage.)
Selection of the displayed bank is complete
when the [WRITE] key is pressed.
The displayed bank number stops flashing
and lights continuously.
(The ON display starts flashing.)
4.8 Bank Function (F7/F8/F9)
CHECK
CAM STEP
ON
ADV BANK
PRG
TCH
TEST
ANGLE
M A N
RUN
CW
ANG
PLS/R
DSPL ORIGIN CLEAR
ON
OFF
CCW DO NOT USE
CAM
STEP
OFF
SET
4-27