Siemens SIMOTION C Operating Instructions Manual page 104

Connecting
5.1 Wiring
Connection of drives (e.g. SIMODRIVE 611 universal with analog setpoint interface) to the onboard
drive interface (C230-2, C240)
The figure below shows the connection of the C230-2, C240 to SIMODRIVE 611 universal
drive units.
Figure 5-8
Procedure:
1. Wire the free cable end of the connecting cable to the terminals on the drive unit. (The
2. Open the front cover of the C230-2/C240 and connect the Sub-D socket (50-pin) to the
3. Lock the connector using the finger screws. Close the front cover.
104
Connection of a SIMODRIVE 611 universal drive unit
terminal markings on the cable ends indicate the corresponding terminals for
SIMODRIVE devices.)
X2 connector.
SIMOTION C
Operating Instructions, 02/2012