Siemens SIMOTION C Operating Instructions Manual page 144

Commissioning
7.1 Requirements for commissioning
Connecting a PG/PC to a SIMOTION C
You can interconnect the programming device / PC
● with the PROFIBUS of SIMOTION C (connector X8 and/or X9) using a connecting cable
● to the Ethernet of the SIMOTION C (connector X7) with a shielded twisted pair cable.
● to the PROFINET interface X11 (port P1, P2 or P3) of the C240 PN with a shielded
144
(see chapter Network components for a PROFIBUS subnet (Page 125)).
Information on the respective cable lengths for PROFIBUS DP can be found in chapter
Onboard measuring system interface (C230-2, C240) (Page 52).
For information about cabling the Ethernet subnet, refer to chapter Configuring an
Ethernet subnet on the Ethernet interface (Page 127).
twisted pair cable.
For information about cabling the PROFINET subnet, refer to chapter Configuring an
Ethernet subnet on the PROFINET interface (C240 PN) (Page 129).
SIMOTION C
Operating Instructions, 02/2012