Siemens SIMOTION C Operating Instructions Manual page 107

Connection of stepper drives (e.g. FM STEPDRIVE) to the onboard drive interface (C230-2, C240)
The figure below shows the connection of the C230-2, C240 to FM STEPDRIVE drive units.
Figure 5-10
Procedure:
1. Insert the Sub-D socket (15-pin) in the FM STEPDRIVE module.
2. Open the front cover of the C230-2/C240 and connect the Sub-D socket (50-pin) to the
3. Lock the connector using the finger screws. Close the front cover.
SIMOTION C
Operating Instructions, 02/2012
Connection of FM STEPDRIVE drive units
X2 connector.
Connecting
5.1 Wiring
107