Inserting And Changing The Micro Memory Card - Siemens SIMOTION C Operating Instructions Manual

7.2

Inserting and changing the Micro Memory Card

Procedure:
1. Switch off the power supply module.
2. Is a micro memory card inserted? If yes: remove the memory card.
3. Applying slight pressure, insert the ("new") micro memory card into the slot of the
4. Switch the power supply module on again.
Figure 7-1
SIMOTION C
Operating Instructions, 02/2012
An ejector is located on the frame of the module receptacle to enable you to remove the
micro memory card.
Press the ejector and remove the micro memory card.
SIMOTION C until it snaps into place. Make sure the beveled edge of the micro memory
card faces the ejector (see the following figure).
Inserting the micro memory card into the SIMOTION C
Note
With the SIMOTION C240 / C240 PN, the micro memory card must always be inserted
for operation.
For the purpose of data backup, the contents of the micro memory card can be copied to
the hard drive of a PG/PC with an MMC card reader.
7.2 Inserting and changing the Micro Memory Card
Commissioning
145