Commissioning
7.6 Deleting data
Memory reset with the mode selector
Note
The operation for the memory reset with the toggle switch is described below. The operation
with the key-operated switch of the C230-2 is similar to the operation with the toggle switch.
Proceed as follows (see following figure):
1. Set the mode selector to STOP.
2. Move the switch to MRES and hold the switch in this position until the STOP LED
3. Within 3 seconds, you must release the switch and return it to the MRES position. The
The SIMOTION C has reset the memory.
Figure 7-4
156
changes from flashing to steady illumination.
memory reset will now be performed. All the LEDs will light up during this time. The
SIMOTION C completed the memory reset when the STOP LED lights up.
Mode selector operation sequence for the memory reset
SIMOTION C
Operating Instructions, 02/2012