Shuttle Recovery Owner's Manual page 8

Step 3: Attach Support Tubes (Box 2)
1. Locate the 3 black support tubes.
2. Starting with tube 2 (marked inside of tube end), remove the nut from the RH end of the
threaded rod and align in respective hole in frame panel, matching assembly sticker to
assembly sticker as shown below. Replace nut. Lightly tighten.
3. Repeat with tube 4 (and tube 5, if assembling a Recovery Senior).
4. Repeat with tube 3, taking note that tube 3 includes a washer and nut.
5. When finished, tube 4's Elasticord Lanyard Plate should be oriented with labels facing up
toward the metal rails of your frame and resting against the stop protruding from the frame.
6. Remove nuts and washers from opposite end (LH) of all tubes.
Page 8 of 73