Troubleshooting - Gabarron ECOSSH158 Installation Instructions And User Manual

4.- REMOTE OPERATION USING THE WIFI G-CONTROL HUB
It is possible to control the full operation of the unit remotely with Gabarron-Elnur app or app-web. The unit must be
connected to a Wifi G-Control Hub connected to the internet to use this feature.
4.1 To associate the unit to the G-Control Hub, the discovery mode of the hub must be activated. Press the associate button at
the back of the Gateway for 3 seconds. An orange flashing light every second indicates association mode.
4.2 With the hub in association mode, press
You control and adjust the programming and temperatures on the SSH via the Gabarron-Elnur app.
4.3 To disassociate the unit, a reset of the unit must be realized. See "DEFAULT SETTING & UNIT RESET". When the heater
is reset, it will remove the programming and revert back to the default settings and also disassociate from the RF network and
G-Control Hub.

5.- TROUBLESHOOTING

ECOMBI SSH does not heat.
ECOMBI does not reach set up
temperature
Err Message in display
Keyboard does not respond
SSH does not communicate
with the G Control Hub.
on the heater for 3 seconds until the Link symbol
Please check it is connected and switched on.
Make sure the device is not covered or the lower air inlets are not obstructed. The LR safety limit
may be activated; in this case it is necessary to reset it manually. Please contact technician.
Make sure that adequate temperature is selected.
Make sure the heater is sized correctly for heat loss.
Please contact technician.
If the "Lock" message is displayed, the thermal radiator keyboard is locked. Hold "+" and "-" buttons
simultaneously for 3 seconds to unlock the keyboard. (See Keyboard Lock Section).
Check the unit is associated, the symbol
For distances greater than 30 metros and 2-3 walls, associate first the closest units. Each
unit can work as signal extender.
If symbol is flashing, check the G Control Hub connexion to the network, and if any
other device in the RF Net that could be working as signal extender has been removed.
must be shown on the display LCD.
15
is shown.