Default Settings; Default Values; Troubleshooting - Gabarron ECOHHR20 Advanced Installation Instructions

3.9.DEFAULT SETTINGS:

By pushing the clock key
panel, software resets to the default settings. Four horizontal blinking segments will appear in the screen to confirm it.
The default programming, all time intervals in frost protection temperature level are set.

Default Values

Sun: Comfort temperature
Moon: Economic temperature
St: Initial % of storage charge
P01: Starting time off peak period 1
P02: Ending time off peak period 1
P03: Starting time off peak period 2
P04: Ending time off peak period 2
P05: Ambient sensor Offset
P06: Max. Balance resistance – working period
P07: Overtemperature protection
P08: Temperature Unit
Open: Open Window Detection Function
Default Programming
Frost protection temperature
i
Incorrect time settings, erroneous programming of the reduced rate time and too high temperature settings may result in
a high cost of your electricity bill.

4.- TROUBLESHOOTING

HHR does not heat
HHR does not reach set up
temperature
ERR 1 in display
ERR 2 in display
ERR 3 in display
Keyboard does not respond
at the same time as we turn on the heater with the power switch, located at the right-side
Please check it is connected and switched on.
Make sure the device is not covered or the lower air inlets are not obstructed. The LR safety limit
may be activated; in this case, it is necessary to rearm it manually. Please contact technician.
Make sure that adequate temperature is selected.
Make sure the heater is sized correctly for heat loss.
Ambient temperature sensor trouble, please contact technician.
Air outlet temperature sensor trouble, please contact technician.
Core temperature sensor trouble, please contact technician.
If display shows [ - - ] when pressing a key, the display is blocked. Press the "+" and "-" key at the
same time for three seconds to unblock it.
21ºC
18ºC
80%
00:00
07:00
00:00
00:00
0ºC
5 hours
2ºC
ºC
Off
Frost Protection 24h*7
3ºC (Fixed value)
11