Table of Contents
Advertisement
Access to the parameter
Change Value: Decrease
Confirm Value
WEEKLY CHARGE PERIOD SETTING
Weekly charging days (UP06 parameter)
Charging/Not Charging day 1
Advance to the next day
Use
and
to move on through the different parameters.
Use
to access the parameter you want to modify. Change the value using the
navigation keys
and
It is possible to save the changes and exit at any moment by pressing
SSH general parameters that can be modified by the user are detailed below:
- UP01: Initial % of storage charge.
- UP02: Starting time of reduced (off-peak) rate electric period.
- UP03: Ending time of reduced rate electric period.
- UP04: Starting time of the second reduced rate electric period. (if not
available set up 00:00).
- UP05: Ending time of the second reduced rate electric period. (if not
available set up 00:00).
- UP06: Charging days during the week.
- UP07: Temperature ambient sensor correction (values from -5ºC to 5ºC).
- UP08: Maximum working period of the emitter in on peak electric period.
Set up this value to "0" to cancel the emitter operation. With balance
resistance operation cancelled, the charge correction will not operate and
the same charging level will be applied every day. (Default 5 hours)
- UP09: Excess of temperature protection during the charge, Degrees
higher than the comfort set point temperature when the charge is
interrupted. (Values 1,2,3,4 & 5).
- UP10: Degrees Celsius or Fahrenheit. (Values: ºC – F).
- UP11: Open Window Detection Activation. (On/Off).
- UP12: Adaptive Start Control Activation (On/Off).
- UP13: Kind of temperature control. Recommended & default PID.
i
ECOMBI SSH does not change automatically from summer time to winter time
or vice versa when not connected to the internet. Depending on the tariff it may be
necessary to change the clock settings to fit these two timings.
Access to the general setting to modify the charging period of your SSH storage
heater. (See "General Setting" above). By default, 00:00 to 07:00 charge period is
set in every day in the week.
Charge period
Two charging periods can be selected in the electronic control of your SSH.
- 1º Charging period: UP02 to UP03. (00:00 to 07:00 by default).
- 2º Charging period: UP04 to UP05. (Disabled by default, 00:00 to 00:00).
Weekly charging days
It is possible to select which days SSH will charge and which days it will not.
Access to the UP06 parameter to modify the days you want your SSH takes a
charge. (By default, 7 days of the week).
Access to UP06 parameter by pressing
the display and the charge condition (On/Off) is displayed.
Press
and
to change the charge condition for this day. Press
on through the days.
12
. Confirm the new value with
. The first day indicator in the top of
.
.
to go
Hide quick links:
Advertisement
Table of Contents
