Table of Contents
Advertisement
AUTO MODE – Programming & Time Setting
Programming
Enter programming:
Select temperature level:
Next 1 hour Time Interval:
Time Setting
PROGRAMMING
Press & Hold
until the following is shown.
The first segment will start to flash. By pressing
want a Frost Protection setting
setting
(21°C). Now press
Once you've gone through all the time intervals for day 1, you will automatically
start on day 2 by pressing
days.
If you do not desire to modify the programming of a day within the week, press
to go through the next day.
i
SSH will not charge in Frost Protection time intervals.
TIME SETTING
After pressing
when the last time interval for day 7 is flashing or after
pressing
in day 7, the time setting configuration starts. The following is
shown with the day of the week flashing.
Use
and
to select today's date. 1=Monday, 2=Tuesday, Etc. and Press
to confirm.
Now the hours start to flash. Press
(hour) and Press
to confirm.
Now the minutes start to flash. Press
time (minutes) and Press
i
If the device is associated with a G-Control Hub, the adjustment of time is
removed and the time in the G-Control Hub is configured in the heater automatically
If you do not desire to modify the time setting, press
the time, the display will show and start to run the program and will flash
between the set temperature for the current day, time interval and the word
Pro to indicate the heater is running the set program.
10
you can select whether you
(3°C), Moon setting
to move to the next 1hour time interval.
. Repeat the above steps until you go through all 7
and
until you reach the correct time
and
until you reach the correct
to confirm.
(18°C) or Comfort
to exit. After setting
Hide quick links:
Advertisement
Table of Contents
