Troubleshooting - Gabarron Elnur ECOMBI SSH Series Installation Instructions Manual

5. TROUBLESHOOTING

ECOMBI SSH does not heat.
ECOMBI SSH does not reach set up
temperature
"Err" Message in display
Keyboard does not respond
ECOMBI SSH does not communicate
with the G Control Hub.
Elnur powered by Gabarrón | ECOMBI SSH | Installation Guide
Please check it is connected and switched on.
Make sure that adequate temperature is selected.
Make sure the storage heater is sized correctly
for heat loss.
Please contact technician.
If the symbol is displayed, the keyboard is
locked. Hold "+" and "-" buttons simultaneously
for 3 seconds to unlock the keyboard.
(See Keyboard Lock Section).
Check the unit is associated, the symbol
must be shown on the display LCD.
For distances greater than 30 metros and 2-3
walls, associate first the closest units. Each unit
can work as signal extender.
If symbol is flashing, check the G Control
Hub connexion to the network, and if any other
device in the RF Net that could be working as
signal extender has been removed.
13