Power Supply Filters - Baldor MDH1A05TB-RC23 Installation Manual

Note: Power to single phase models may be derived by connecting two phases of an
appropriate three-phase supply (L1 and L2 for example). When supplying AC
power in this way, the voltage between the two phases must not exceed the rated
input voltage of the MintDrive
lines. Fuses must be fitted in both lines. Circuit breaker or fuse are not supplied.
For CE compliance, see Appendix D.
From
supply
L1
L2
L3
Figure 5 - Circuit breaker and fuse, three-phase (package sizes E, G, H)
Note: Metal conduit or shielded cable should be used. Connect conduits so the use of a
line reactor or RC device does not interrupt EMI/RFI shielding.

3.4.5 Power supply filters

To comply with EEC directive 89/336/EEC, an AC power filter of the appropriate type must be
connected. This can be supplied by Baldor and will ensure that the MintDrive
the CE specifications for which it has been tested. Table 1 lists the appropriate filters:
MintDrive
current current
rating
2.5A
5A
7.5A
15A
20A
27.5A
All single-phase MintDrive
reducing the amount of panel area required for filter and drive.
3-12 Basic Installation
Circuit Breaker
L1
L2
L3
II
115VAC, 1Φ
FI0015A00 or FI0029A00
FI0015A02 or FI0029A00
FI0029A00
Table 1 - Baldor filter part numbers
II
models can be mounted directly onto the body of filter FI0029A00,
II
. A two pole breaker must be used to isolate both
From
supply
L1
L2
L3
Circuit breaker or fuse are not supplied.
For CE Compliance, see Appendix C.
Input voltages
230VAC, 1Φ 230VAC, 3Φ
FI0018A01
www.baldormotion.com
Fuses
II
complies with
230-460VAC, 3Φ
FI0018A00
FI0018A00
FI0018A00
FI0018A01
FI0018A01
FI0018A01
MN1901