Configuring Dispense Mode - SATO MB200i Operator's Manual

Operation and Configuration

Configuring Dispense mode

Dispense Mode can be set to Auto Print or Manual
Print, as described below.
Type
Auto Print Prints one label after receiving data and waits for peeling.
After peeling a label, automatically prints another label.
Manual Prints one label after receiving data and enters offline
Print (this
state. Pressing the PRINT key allows another label to be
is the
printed. After printing the specified number of labels, print-
default set-
ing terminates. Printing will not occur even when the
ting)
PRINT key is pressed.
To switch between Auto or Manual Print for the
Dispense Mode, set the dipswitches and then hold
down the PRINT or FEED button when powering on
the printer. The new settings take effect when the
printer is powered on again.
Setting Auto Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open + Print
button + power ON
Setting Manual Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open + FEED
button + power ON
When setting the dispense mode, the STATUS LED
blinks green and turns into a steady green signal
upon setup completion. Power off the printer only
when the STATUS LED is a steady green light.
3-12
Operation