SATO MB200i Operator's Manual page 27

Installing the label roll (cont'd)
3. Open the label guide dial
cover and turn the dial till
the label guides press
loosely against label roll.
Manually rotate the media
roll to confirm that it moves
smoothly. Otherwise paper
will not be fed correctly
during operation. Close the
dial cover.
* When replacing a label roll
of the same width as that
previously used,
adjustment of the label
guide is not necessary.
4. Close the cover after confirming that the media's
leading edge is protruding beyond the printer.
This completes media installation for continuous
mode operation.
Setup
2-13