Table of Contents
Advertisement
Operation and Configuration
Configuring Dispense mode
Dispense Mode can be set to Auto Print or Manual
Print, as described below.
Type
Auto Print
Prints one label after receiving data and waits for peeling.
After peeling a label, automatically prints next label.
Manual
Prints one label after receiving data and enters offline
Print (this
state. Pressing the PRINT key allows next label to be
is the
printed. After printing the specified number of labels, print-
default set-
ing terminates. No printing occurs even when the PRINT
ting)
key is pressed.
To switch between Auto or Manual Print for the
Dispense Mode, set the DIP switches and then hold
down the PRINT or FEED button when turning the
printer ON. The new settings take effect when the
printer is next turned ON.
Setting Auto Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open + Print
button + power ON
Setting Manual Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open + FEED
button + power ON
When setting the dispense mode, the STATUS LED
blinks green, and turns into a steady green signal
upon completion of setting. Turn off the printer ONLY
when the STATUS LED is a steady green light.
3-12
Operation
Advertisement
Table of Contents
