SATO MB200i Operator's Manual page 45

Operation and Configuration
Printer modes (cont'd)
Head Check Setting Mode
Head checking can be applied to one of two areas:
the normal print area and the barcode print area.
To specify the area subjected to a head check, follow
the settings in the table below:
Setting Head Check Area
(cover must be left open)
H.Check setting DSW-1 DSW-2
Normal Print Area OFF ON
Disable H. Check OFF ON
Barcode Print Area ON OFF
Disable H. Check ON OFF
You can check the current setting with a test printout
as described in "Performing a Test Print" on page 2.
When setting the Head Check options, the STATUS
LED blinks green, and turns into a steady green
signal upon setup completion. Power off the printer
only when the STATUS LED is a steady green light.
DSW-3 DSW-4 Other keys
OFF ON hold down PRINT
button
OFF ON hold down FEED
button
OFF ON hold down PRINT
button
OFF ON hold down FEED
button
3-15