Charging The Battery Pack With A Charger - SATO MB200i Operator's Manual

Charging the battery pack with a charger

If the printer is purchased with the optional charger,
follow the steps below to charge batteries:
1. Connect the charger to the
wall. The POWER lamp
lights red.
2. Orient the battery pack with
its metal contacts facing
frontward, then slide it
forward into the charger.
The CHARGE lamp lights red
when charging begins and
turns off when the battery
pack is fully charged.
In the case of a five-battery
charger, the CHARGE lamp
glows red when charging
begins and then glows
green when the battery
packs are fully charged.
3. After charging, remove the
battery pack from the
charger by sliding it out.
Setup
metal contacts
2-5