SATO MB200i Operator's Manual page 56

Troubleshooting
STATUS Mode Description
(LED)
Light (Red) All Low battery
modes
Blink (Red) Online Error in
every 2s Bluetooth or
WLAN card
Light (Red) After 1 Program
Power illegal
On error
2 Flashrom-
error
Blink Online Head error
(Green-
ÌRed) every
2s
Blink (Red) Online Cover open
every Paper End
1s Sensor
error
Blink Online Buffer
(Green) at (Printing near-full
0.5s or receiv-
intervals ing data)
Blink All Sleep mode
(Green) modes
every 4s
Blink All Head over-
(Green->off- modes heat
>Red->off) protection
every 1s feature
* Contact the nearest dealer or SATO representative for support
6-2
Cause Remedy
Battery charge level is low. Recharge the battery
Interface module error Replace the board
(Bluetooth, wireless LAN)
Flash ROM read/write 1 Replace Flash
error has occurred ROM*
2 Retry downloading
program*
Head wiring is Replace the head*
disconnected
1 Cover is not locked 1 Lock the cover
1 Paper is not present 1 Load paper
1 Wrong sensor level 1 Adjust sensor level*
2 Cover-open/close sensor 2 Adjust sensor level*
malfunctioning 2 Set correct sensor
2 Wrong sensor type type
3 Paper skew 3 Reload paper
Insufficient space in Stop sending data
Receive Buffer area from the host and
wait till the buffer
becomes empty.
Resume sending
data.
Not in error. Low power Clear this mode by
consumption mode is receiving data, press-
active ing a key, opening or
closing the cover.
When print head is hotter Cleared when the
than 70°C the print head head temperature
overheat protection feature drops to 50°C
is activated. Not in error.