Choosing The Label Dispensing Mode; Configuring Dispense Mode - SATO MB410i Operator's Manual

Unit 4: Operation and Configuration

CHOOSING THE LABEL DISPENSING MODE

You can choose to dispense labels in Continuous Mode and Dispense Mode. In either mode, test
printing and online printing are available.
You can select Dispense mode for linerless labels by using the MB400i/MB410i utility.

CONFIGURING DISPENSE MODE

TYPE
Auto Print
Manual Print
(this is the
default
setting)
Dispense Mode can be set to Auto Print or Manual Print, as described in Table 4-1, above.
Page 4-26
Test printing
Prints the printer status
Online printing
(Receives data from a PC or
handheld terminal and prints it)
Continuous printing
Dispenser printing
(label paper/linerless label/
Journal paper)
Figure 4-23, Available Modes and Options
Table 4-1, Dispense Mode Settings
OPERATION
Prints one label after receiving data and waits for
peeling. After peeling a label, automatically prints
next label.
Prints one label after receiving data and enters
offline state. Pressing the PRINT key allows next
label to be printed. After printing the specified
number of labels, printing terminates. No printing
occurs even when the PRINT key is pressed.
PN 9001190C
Continuous printing
Dispenser printing
Continuous printing
Dispenser printing
Dispenser printing
(Linerless label with
(label paper)
perforation)
MB400i/MB410i Operator Manual