SATO MB200i Operator's Manual page 30

Setup
Installing the label roll (cont'd)
3. Ensure the leading edge of
the media extends beyond
the printer by at least
10mm.
* When using linerless
labels, press the FEED
button to advance the
media. Then pull the
label upward to cut along
the perforation. If the
label becomes jammed,
perform the label setting
procedure again.
4. Push the dispenser unit
forward so that it covers
the red platen roller.
This completes media
installation for Dispense mode operation. To
resume operation in Continuous mode, lift the
top edge of the dispenser unit (where two arrow
marks are imprinted) and slide it to its home
position. In Continuous mode, the red platen
roller will be visible.
2-16