Table of Contents
Advertisement
Configuring FR DE rule list
Step
1.
Enter system view.
2.
Configure a DE rule list.
3.
Enter FR interface view.
4.
Apply the DE rule list to the
specified FR PVC.
Configuring FR PVC queuing
With FRTS enabled on an FR interface, each FR PVC of the interface is configured with an
independent queuing mechanism.
Configuration restrictions and guidelines
•
By default, FR PVCs use FIFO queuing.
•
With congestion management enabled, an FR interface supports only FIFO queuing.
•
With congestion management enabled, an FR PVC supports only FIFO queuing.
Configuration procedure
Step
1.
Enter system view.
2.
Enter FR class view.
3.
Configure FIFO queue
length for the FR PVC.
Configuring FR fragmentation
The devices support end-to-end FRF.12 fragmentation.
Command
system-view
•
Configure an interface-based DE rule
list:
fr del list-number inbound-interface
interface-type interface-number
•
Configure an IP-based DE rule list:
fr del list-number protocol ip [ acl
acl-number | fragments |
greater-than bytes | less-than bytes |
tcp ports | udp ports ]
interface interface-type interface-number
fr de del list-number dlci dlci-number
Command
system-view
fr class class-name
fifo queue-length queue-length
132
Remarks
N/A
Use one of the commands.
By default, no DE rule list is
created.
N/A
By default, no DE rule list is
applied to an FR PVC.
Up to 10 DE rule lists can
be applied to a device, and
a DE rule list can be
configured with up to 100
DE rules.
Remarks
N/A
N/A
Optional.
The default setting is 40.
Advertisement
Table of Contents
