7. Configuring the Printer Using the
Operation Panel
The following operations can be performed from the control panel after changing the
printer operation mode to the special mode.
Adjust media sensors
Print test samples
Print the settings configuration
Change emulation modes
HEX dump mode
Initialize the printer
*This device is not equipped with the [Menu Configuration Mode] featured in other
models.
1.
With the top cover closed, turn on the power to the printer while pressing and holding
the FEED key.
The printer changes to the special mode.
The buzzer emits 3 short tones and the status LED flashes alternately in green and red.
2.
Press the FEED key to select the desired operation mode.
Mode
Special function mode
Sensor Adjustment Mode
Test print mode
Configuration print mode
Buzzer
3 short tones
Alternately in green and
Press the FEED key ↓
1 short tones
Press the FEED key ↓
2 short tones
Press the FEED key ↓
3 short tones
Press the FEED key ↓
70
—
Status LED
Color
red
Green
Green
Amber
—
Interval
Flashes quickly
Flashes
Flashes quickly
Flashes