Basic Specifications - Citizen CL-E321 User Manual

Status Buzzer
LED
Flashes Rep- Head Low Tempera-
in amber etitions ture Error
of long
tones
Flashes None Head High Tempera-
in amber ture Alarm
Motor High Tem-
perature Alarm
Flashes Rep- RS-232C Communi-
alter- etitions cation Error
nately in of long
red and tones
green
Flashes Rep- Hardware Error
alter- etitions
nately in of long
red and tones
amber
This product does not have a broken head element check function so if there are vertical white
lines that you suspect are caused by a broken head element, clean the thermal head and then
perform a print check in the sample print mode.
If the white line problem is not resolved, the head element may be broken.

11.2 Basic Specifications

Printing
Item
Print method Direct-thermal / thermal-transfer printing
Resolution CL-E321
CL-E331
Max. print width CL-E321
CL-E331
Max. print length CL-E321
CL-E331
Print density Print density is adjustable with software
Error Error description (in bold) and resolution
The thermal head is at a low temperature (approximately
-10°C).
Use the printer in proper environments of at least 0°C.
Ÿ
The thermal head is not connected.
Check the cable connection with the thermal head.
Ÿ
The thermal head or feed motor is at a high temperature.
Ÿ Printing stops if the thermal head reaches approximately
70°C or more while printing. Printing resumes automatically
once the temperature falls to approximately 60°C or lower.
Ÿ Printing stops if the feed motor reaches approximately 95°C
or more while operating. Printing resumes automatically once
the temperature falls to approximately 85 °C or lower.
Parity error
Framing error
Receive buffer is full
Transmission buffer is full
Ÿ Check the communication settings.
A hardware error has been detected.
Immediately turn off the power to the printer and contact your
Ÿ
retailer.
Main scanning line density: 203 dots/inch (8 dots/mm)
Sub-scanning line density: 203 dots/inch (8 dots/mm)
Head dots: 864 dots (effective dots: 832)
Main scanning line density: 300 dots/inch (11.8 dots/mm)
Sub-scanning line density: 300 dots/inch (11.8 dots/mm)
Head dots: 1248 dots (effective dots: 1240)
104 mm / 4.1 inch
105 mm / 4.1 inch
(Datamax) 2539.7 mm/99.99 inch
(Zebra) 2540.0 mm/100.00 inch
1,270.0 mm / 50.00 inch
86
—
Description
—