Sensor Adjustment - Citizen CL-E321 User Manual

Ÿ Using label media with gaps
Peel a label and set the media so that only the backing paper (glassine paper) reaches the
platen roller and media sensor.
3. Adjust the sensors.

Sensor adjustment

1. Turn on the power to the printer while pressing and holding the FEED key to start the
printer in special function mode.
2. Press the FEED key once to select sensor adjustment mode.
The buzzer emits 1 short tone.
The status LED also flashes in green.
3. Press and hold the FEED key for at least 3 seconds.
4. Release the FEED key once the buzzer emits a long tone and then press the FEED key
again.
The printer is now in sensor adjustment mode.
5. Press the FEED key to select either transmissive sensor or reflective sensor.
Each press of the FEED key toggles between transmissive sensor and reflective sensor op-
tions.
Sensor
Transmissive sensor
Reflective sensor
6. Press and hold the FEED key for at least 3 seconds.
Black
mark
Bottom sensor
Buzzer
1 short tones
Press the FEED key ↕
2 short tones
Label
Liner
media
Color
Green
Green
73
— —
Refer to Sensor adjustment
Status LED
Interval
Flashes
Flashes quickly