Test Print Mode - Citizen CL-E321 User Manual

7. Release the FEED key once the buzzer emits a long tone.
The sensor adjustment process starts.
Ÿ Once sensors have been adjusted, the buzzer emits 1 short tone, and the printer restarts.
Ÿ The buzzer emits 1 long tone if sensor adjustment fails. If this happens, check the sensor
and media positions.

To cancel sensor adjustment, continue pressing and holding the FEED key for at least
3 seconds at step 7.
The buzzer emits 4 short tones, and the printer restarts.

7.2 Test print mode

This mode prints the test sample.
This printer can print test samples to label media and continuous media.
Printing test samples is a quick way to check print quality.
Load media and then perform the following procedure.
1. Turn on the power to the printer while pressing and holding the FEED key to start the
printer in special function mode.
2. Press the FEED key twice to select test print mode.
The buzzer emits 2 short tone.
The status LED also flashes quickly in green.
Dimension of
media feed
74
— —