2.
Press the FEED key 5 times to select HEX dump mode.
The buzzer emits 5 short tone.
The status LED also flashes in red.
3.
Press and hold the FEED key for at least 3 seconds.
4.
Release the FEED key once the buzzer emits a long tone.
The printer is now in HEX dump mode.
5.
Press the FEED key to select the media.
Each press of the FEED key toggles between label media and continuous media.
Media
Label media
Continuous
6.
Press and hold the FEED key for at least 3 seconds.
7.
Release the FEED key once the buzzer emits a long tone and then press the FEED key
again.
The hex dump list print process starts.
8.
Once the HEX dump list has been printed, turn the power to the printer off and on
again to reset the printer in the normal startup mode.
To cancel HEX dump mode, continue pressing and holding the FEED key for at least 3
seconds without releasing your finger at step 7.
The buzzer emits 4 short tones, and the printer restarts.
7.6 Initialization Mode
This mode is used to initialize printer settings and the user memory area.
1.
Turn on the power to the printer while pressing and holding the FEED key to start the
printer in special function mode.
Buzzer
1 short tones
Press the FEED key ↕
2 short tones
79
—
Status LED
Color
Green
Green
—
Interval
Flashes
Flashes quickly