Chapter 5 Recording And Playback; Recording; Playback - GeoVision GV-VS04H User Manual

Chapter 5 Recording and Playback

The GV-Video Server can record down video/audio directly to the attached USB mass
storage device. And you can play back the recorded files on the GV-DVR / NVR / VMS or
over the TCP/IP network.

5.1 Recording

To enable the recording function:
1. Attach the USB mass storage device to the GV-Video Server. See 4.8.3 Storage
Settings.
2. To set up the pre-recording, post-recording or audio recording, see 4.1.2 Video
Settings.
3. To set up the schedule for video recording or I/O monitoring, see 4.5 Recording
Schedule.
4. To configure the areas and sensitivity values for motion detection, see 4.1.3 Motion
Detection.
5. To start recording by the triggering of input device, configure the operation of I/O
devices. See 4.2.2 Input/Output Settings.
6. To start recording and I/O monitoring, see 4.4 Monitoring.
The GV-Video Server will start recording in case of motion detection, I/O trigger, or during
the scheduled time.

5.2 Playback

Two methods are available to play back the video files recorded at the GV-Video Server:

Playback using the USB mass storage device by attaching it directly to the GV-DVR /
NVR / VMS.

Playback using the Remote ViewLog function over the TCP/IP network
Recording and Playback
5
123