Setting Npd Adjust Offset On The Clock Table; Aborting Npd Adjust Offset; Extending The Npd Bead Life - Agilent Technologies 7890 Series Advanced Operation Manual

Setting NPD adjust offset on the clock table

Aborting NPD adjust offset

Extending the NPD bead life

Advanced Operation Manual
Detector off When the detector is off, Adjust offset and Bead
voltage are Off and initial Output is displayed.
Detector on—detector temperature less than 150 °C. When you
enter an Adjust offset value or press [On], detector gases turn
on and the display blinks the Temp not ready message.
Detector on—waiting for oven and/or detector to reach temperature
setpoint and equilibrium. If the oven or detector is not at
setpoint, the display continues to blink the Temp not ready
message.
Detector on—Dry Bead On If Dry Bead is On, the temperature
rise holds at 150 °C for 5 minutes to remove moisture, then
continues to the setpoint.
Detector on—during adjust offset. When the detector and oven
temperatures reach setpoint and equilibrate, the Adjust
offset process begins. The bead voltage is slowly increased
until the output is close to the Adjust offset value. The display
blinks Detector Slewing.
Detector on and ready. When the Adjust offset value is reached,
the Adjust offset line reads Done and displays the offset target
setpoint. Your detector is on and ready. The display shows
the actual Bead voltage.
You can use the Clock table feature to begin Adjust offset at a
specified time.
Press [Delete] with the cursor on the Adjust offset line. This
cancels the adjustment without turning off the detector gases
and bead voltage.
These actions, together with the automated heatup and
adjust procedures, can extend ceramic bead life considerably.
• Use the lowest practical Adjust offset value. This will result
in a lower Bead Voltage during operation.
• Run clean samples.
• Turn the bead off when not in use.
5
Detectors
197