Fpd + Temperature Considerations; Fpd + Gas Purity; Fpd + Gas Flows - Agilent Technologies 7890 Series Advanced Operation Manual

5
Detectors
+
FPD
+
FPD
+
FPD
202
temperature considerations
The FPD
transfer line (the main detector temperature) and one for
the emission block. For the transfer line temperature, we
recommend a temperature that is 25 °C higher than the
highest column temperature.
The emission block temperature ranges from 125—175 °C.
Typically, the default temperature of 150 °C is sufficient for
most applications. However, when setting the emission block
temperature, consider the following:
• If using the GC oven at high temperature (>325 °C) with
the transfer line set to 400 °C, set the emission block
temperature to 165 °C to avoid a system Not Ready if the
emission block temperature cannot be maintained.
• If using the transfer line at 400 °C, set the emission block
temperature to at least 150 °C to avoid a system Not
Ready.
• For sulfur analyses, the highest area response will be
realized with the lowest possible emission block
temperature.
• For phosphorus analyses, the area response is
independent of the emission block temperature.
gas purity
High- purity gases have a lower sulfur content. Standard
purity gases have a higher sulfur content which impairs
sulfur detection in the compound being studied. Instrument
or Chromatographic grades work well.
Agilent recommends using helium carrier, nitrogen makeup
gas, and air with 99.9995% purity or better. Use carbon,
oxygen, and moisture traps. Select traps to remove sulfur
compounds from detector air and nitrogen gases. A helium
getter is also recommended. See the
Site Preparation Guide
http://www.agilent.com
gas flows
Table 53
flame, which is hydrogen- rich and oxygen- poor.
+
provides two temperatures zones, one for the
for and the Agilent web site at
more information.
gives the flows for the maximum sensitivity FPD
GC, GC/MS, and ALS
Advanced Operation Manual
+