Fpd Linearity; Fpd Lit Offset; Starting Up And Shutting Down The Fpd; Fpd Photomultiplier Protection - Agilent Technologies 7890 Series Advanced Operation Manual

FPD linearity

FPD Lit Offset

Starting Up and Shutting Down the FPD

FPD photomultiplier protection

FPD optical filters

Advanced Operation Manual
Several mechanisms produce sulfur emission. The excited
species is diatomic, so that emission intensity is
approximately proportional to the square of the sulfur atom
concentration.
The excited species in the phosphorus mode is monatomic,
leading to a linear relationship between emission intensity
and atom concentration.
The default Lit Offset is 2.0 pA.
The FPD creates a great deal of water vapor when the flame
is on. This could condense in the vent tube on top of the
detector and drop onto the flame, possibly extinguishing it.
To avoid this, turn the heaters on, wait 20 minutes for the
vent to heat up, and then ignite the flame. Water vapor will
now make it over the top of the vent tube before condensing.
For similar reasons, extinguish the flame before turning the
heaters off.
The PMT is extremely sensitive to light. Always turn the PMT
voltage off (which turns off the high voltage to the PMT)
before removing the PMT housing or opening the emissions
chamber. Failing to do this can destroy the PMT.
Even with the PMT voltage off, protect the PMT from room
light. Cap the housing when removed, place it end down to
exclude light, reduce room light level before exposing the
PMT, and so on. A brief exposure (always with the PMT
voltage turned off) will not damage it but prolonged exposure
will cause a gradual loss of sensitivity.
The filters are marked on the edge with the transmission
wavelength. Each filter has a small arrow on its side which
must point toward the PMT when installed.
The sulfur filter is silvery on both sides and transmits at
393 nanometers.
5
Detectors
207